Menu
Liên Hệ
– This charger is intended for the Li-Po battery.
– Uses the SMPS for power when charging, thus it must be accompanied with the SMPS 12V 5A.
– Support 2S and 3S Cell charge. (Exception, does not charge simultaneously)
|
LIPO Battery Charger LBC-010 |
1 |
|---|
* Battery and SMPS 12V 5A sold separately.
| Input Voltage | 10 ~ 18V |
|---|---|
| Output Voltage |
2S Cell: 8.4V 3S Cell : 12.6V |
| Output Current | 1.1A |
| Status |
RED LED : Charging GREEN LED : Charge Complete BLINKING RED LED : Bad Battery Connection |
LIPO 11.1V Battery Set LB-010, LB-011, LB-012
– Do not apply heat, water or any other liquid on the battery.
– Do not take the battery apart.
– Do not use damaged batteries. (inflated, deformed, damaged, etc.)
– Do not charge 2S and 3S Cell together at once.
– When charging, make sure the battery is connected into the correct polarity.
– Do not charge when the battery is hot. Please charge after it has cooled off.
– Do not charge the battery when it is being used by the controller.
– When the battery is not being used or fully charged, please do not have it connected to a device. (to avoid discharge or damage)
